Adhesive glue will not stick to a surface that is dirty or dusty.Dry the plaster thoroughly when finished. Before you attach an adhesive to a plaster wall, you need to clean the surface of the plaster to strip away any oils and dirt. Note that there are also anchors made from fiber, wood, and metal, however, so you have a range of options to choose from. Plastic anchors are among the most common and will usually suffice for this project.This sleeve also minimizes the amount of stress put on the plaster. As a result, the screw will sit more securely inside the wall. Wall anchors consist of a sleeve that expands into the wall once you drive a screw into it.Note that the anchor should also be flush with the wall.The anchor needs to be snug and straight inside the wall. If the anchor starts bending, you should take it out and make the hole a little larger. If your hole is not large enough, a plastic anchor will bend.Remove the tape covering your hole before hammering the anchor inside.Tap the anchor into the hole, using just enough force to drive it in without bending the anchor or cracking the wall. Place the anchor directly over the hole in your wall. Note: You can distribute the weight of a very heavy mirror over multiple toggle bolts.Hammer an anchor into the wall. Again, the packaging should tell you the maximum weight load your toggle bolt can safely handle. The toggle bolt pictured here (one-quarter inch in diameter by 3 inches long) holds up to 90 pounds in half-inch drywall. Mirrors heavier than 100 pounds need to go into the stud or you need to use toggle bolts, says Gilligan, the D.C. This gap is where you will hang the mirror’s wire or hardware. Tighten the bolt, leaving a gap between the bolt head and the washer and nut. This locks the bolt into place so the screw can’t be pulled out of the drywall. As you do so, the toggle will open its wings, as shown here. Then you make a large hole in the wall with a drill, insert the closed toggle bolt and tighten the screw. You will need to put a nut and washer on the toggle bolt first. Toggle bolts are a good option for hanging a heavy mirror when there is no stud behind the wall. A toggle bolt is made up of a screw and a spring-loaded toggle. If you have concrete, brick, quarried stone, marble, or a delicate wall surface like wallpaper that you don’t want to damage, you would be wise to call in a pro, says Benjamin Gilligan, an art installer in Washington, D.C., who has worked at Christie’s and the Metropolitan Museum of Art.Īn art installer or framer, or a knowledgeable person at a hardware store, can help you assess any specific challenges your walls may present and help you determine the appropriate wall hardware.īrowse wall mirrors by size, shape and style Concrete and brick, for instance, require an impact driver. If your wall is made of harder materials like brick, concrete, stone or tile, you’ll likely need a specialty drill, or help from a pro. To hang a heavy mirror on drywall, you simply need a standard drill, which you’ll use to screw your hanging hardware into the drywall, ideally at the stud. Your wall material is a key factor that will help determine what tools and hardware you should use.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |